![]() ![]() Take any 3/4" coupler and saw off about half an inch from one of the ends, then slide that piece about half way across the 3/4" pvc sectionĪt the other end of the 3/4" pvc you should glue on a rubber cap, mine was a little fancier than most rubber caps which is good. insert a 90 degree coupler on the left side, and glue it into place insert these sections into the remaining openings of the 4 way coupler cut 3 sections of 3/4" pvc about 1" per section dremel out the insides of the spigots so the 1/2" pvc fits nice and snugly inside ![]() Then you need to cut the 3/4" pvc to be 15"Īdd a 4-WAY COUPLER at the end of the 3/4" pvcĪfterwards you are going to need 2 3/4" 90 degree couplers with spigots By default the installer will use the drive with the most available free space as the datastore for AMP instances. Download the installer and run through the wizard. First off you're going to want to cut two equal sections of 1/2" pvc at about 18" long UAC Enabled (AMP will not function correctly if UAC has been disabled) Install the AMP Instance Manager. ![]()
0 Comments
Leave a Reply. |